SkyTrak 6036 Operation Manual - Manual (Page 48)

Page 42
6036/6036T
General Maintenance
This section of the manual contains a routine equipment
checklist and a maintenance schedule and checklist with
references to pertinent procedures and instructions. To
prevent problems before they occur, follow the schedule.
NOTE: The Lubrication and Maintenance Decal found
inside the right rear engine door contains a general
maintenance schedule that should be followed to
maintain this vehicle in good operating condition. The
same schedule is presented in this manual, except it
contains a more detailed account of how to perform
these specific maintenance operations.
Warning
DO NOT perform service or maintenance on the
vehicle with the engine running. Contact with moving
parts can cause serious injury or death.
Routine Equipment Checklist
Inspect the following equipment daily:
Safety Belt
Check for frayed or cut webbing, damaged buckles, or
loose mounting brackets.
Safety Surfaces
Keep all non-skid surfaces clean. Replace safety treads
if worn, damaged or missing.
Warning Decals
Check condition of all decals (Figure 20). Replace if
missing, damaged or illegible.
Covers
Keep all protective covers in place.
Emergency Brake
Check operation. Have unit repaired immediately if
required.
Quick Attach
Make sure that the quick attach pin secures the attach-
ment and that the release lever is seated in the pin
groove.
Engine
Check cleanliness. Remove all dirt or debris, and all
flammable materials before running engine.
Tires
Check tire pressure and hydrofill. Add air and/or hydrofill
if required per "Specifications."