SkyTrak 6036 Operation Manual - Manual (Page 73)

Page 67 6036/6036T
7. If hydraulic oil is to be changed, retract all cylin-
ders, place a receptacle under the reservoir drain
plug. Remove magnetic drain plug and allow oil
to drain into receptacle. Clean loose particles
from plug. Transfer the oil to a container with a
cover and label the container as used oil. Dis-
pose of the used oil at an approved recycling
facility.
8. Re-install magnetic drain plug into reservoir.
OA0382
NUTS
FILTER HEAD
Figure 44
5. Pull the element off of the filter head and discard
the element.
6. Clean filter head sealing surfaces.
9. Push new filter element fully onto the filter head
until it seats against the washer. Re-install filter
head assembly and gasket into the tank and
secure with the nuts removed earlier.
10. Remove reservoir cap and fill the reservoir with
ISO-46 or MIL-L-2104C Oil (See table on page
65.) until the oil level is filled to the minimum oil
level as described in section 7B. Reservoir
capacity is 24 gallons (90,8 liters).
11. If any lines were removed or disconnected be
sure all fittings and connections are tight before
proceeding.
12. Disconnect the fuel run solenoid to prevent the
engine from starting.
13. Turn the ignition switch to START position and
crank the engine for 15 to 25 seconds. This will
prime the main tandem pump.
14. Turn the ignition switch to OFF.
15. Reconnect the fuel run solenoid.
IMPORTANT: DO NOT operate any boom or steer-
ing functions during pump test.