SkyTrak 6036 Operation Manual - Manual (Page 36)

Page 30
6036/6036T
4. Exit the vehicle using the hand holds.
NOTE: Before removing a carriage type attachment,
spread the forks out on the carriage shaft. This will give
the carriage adequate support to stand alone when it is
removed from the boom.
5. Raise the quick attach pin lock lever and pull out
the pin at the bottom of the quick attach link.
6. Return to the operator’s compartment, lower the
attachment to the ground in a level position, and
push the attachment tilt lever forward. This will
rotate the quick attach link back away from the
attachment.
7. Lower, then retract the boom until the boom hook
pins have disconnected from the attachment.
Quick Attach Reconnect
1. Be sure that you are performing this procedure on
level ground. Position the vehicle directly behind
the attachment to be mounted.
2. Push the attachment tilt control lever forward to
rotate the quick attach link back.
3. Extend the boom approximately 10 feet and drive
the vehicle forward until the boom hook pins are
below and between the two hooks on the attach-
ment.
Leveling Frame
When placing a load while on a slope, use the frame
tilt control lever to keep the load level. The operator
should observe the frame level indicator to assure
that the load is level at all times.
Danger
Frame tilting with the boom raised above horizontal can
cause tipover resulting in death or serious injury. Al-
ways use the frame tilt to level the vehicle before raising
the boom above horizontal. If the vehicle cannot be
leveled using the frame tilt, reposition the vehicle.
Quick Attach (See Figure 16)
This telescopic handler is equipped with a quick attach
system for easy attachment changing.
Quick Attach Removal
1. Park the vehicle on level ground.
2. Place travel select lever in (N) Neutral and
engage the emergency brake switch.
3. Extend the boom about 10 feet and tilt the car-
riage backward.