SkyTrak 6036 Operation Manual - Manual (Page 46)

Page 40
6036/6036T
Using Other Attachments
Numerous attachments, some marketed by JLG and some
sold by third party sources, are available for this vehicle.
The general rule is that any attachment used on this vehicle
must be intended for the function of lifting only. This
vehicle is not designed to PULL, TOW or DRAG other
objects. DO NOT use attachments that perform these
functions with this vehicle.
Some JLG attachments are supplied with a capacity chart
that is to be affixed to the vehicle near the original capacity
chart (Figure 20 - #4) for operator reference. Third party
sources may or may not supply capacity charts with their
attachments. Capacity ratings for these type attachments
should be obtained from the third party source.
JLG makes no representations or warranties, express or
implied, as to the design, manufacture or fitness for use
with this vehicle of any third party source attachments.
This vehicle is not intended to be used and should not be
used with any attachment that would alter the center of
gravity stability of this vehicle. JLG assumes no liability for
any third party attachment that would alter the center of
gravity stability.
Following is a list of some of the attachments that are
available through JLG for this vehicle model:
48", 60" and 72" Carriage
1-1/4 Cubic Yard Bucket
Broom
Auger Unit with Drive and Extensions
The standard capacity chart for this vehicle
(Figures 17 & 18A) are applicable for all the above listed
attachments. The attachments listed below are supplied
with their own capacity charts.
5' Straight Mast (Figure 18B)
48", 60" and 72" Sidetilt Carriage (Figure 18C)
52" and 72" Swing Carriage (Figure 18D)
12' Truss Boom (Figure 18E)
Hydraulically actuated attachments also have a maximum
hydraulic pressure rating. Make sure that the maximum
hydraulic pressure of the attachment is equal to or slightly
greater than 2650 psi (182,6 bar), which is the maximum
hydraulic pressure of this vehicle’s auxiliary hydraulics.
IMPORTANT: If the maximum pressure of the vehicle
exceeds the pressure rating of the attachment, the
attachment’s hydraulic components could burst. If the
maximum pressure of the vehicle is much lower than the
pressure rating of the attachment, the attachment may
not work properly.