SkyTrak 6036 Operation Manual - Manual (Page 28)

Page 22
6036/6036T
Normal Starting
1. Using hand holds, enter the cab and adjust the
operator’s seat for comfortable operation.
2. Adjust mirrors to obtain best rear view from operator
position.
Warning
DO NOT start the engine unless you are in the seat
with the seat belt fastened around you. Serious
injury or death could result if the belt is not securely
fastened.
3. Fasten seat belt.
4. Check that the emergency brake switch is engaged.
5. Place the travel select lever in (N) Neutral.
6. Turn ignition switch to START position (fully clock-
wise) to crank engine. Release key when engine
starts. If engine fails to start on first try, wait until
engine and starter come to a complete stop before
cranking engine again.
IMPORTANT: DO NOT crank starting motor continuously
for more than 15 seconds. This will avoid starter motor
overheating.
7. After engine starts, run engine at partial throttle for
30 to 60 seconds before operating the vehicle.
Return to idle before using travel or range select
levers.
8. Disengage emergency brake switch before you start
operating.
Walk-Around Inspection
1. Check the air cleaner restriction indicator for re-
quired service.
2. Check and add engine oil if required.
3. Check cooling system overflow bottle for coolant.
Add coolant if required and remove debris or other
foreign material from the radiator as necessary.
4. Check hydraulic oil level sight gauge and add oil if
required.
5. Walk around the vehicle and check for leakage,
damaged or missing parts, proper tire inflation and
hydrofill. Make necessary repairs before operating.
6. Check the condition of the rims, check for bent
flanges and/or bead mounting areas. On three
piece rims, check the retaining ring on the backside
of the rim for wear or improper fit. Replace any
damaged parts before using the vehicle.