SkyTrak 6036 Operation Manual - Manual (Page 60)

Page 54
6036/6036T
OA0271
Figure 30
OG0030
Figure 29A
ADD
FULL
OIL FILTER
CUMMINS
ENGINES
ONLY
0724650
390
3102
5. Reconnect line to bottom of overflow bottle and
close radiator petcock. Reconnect heater hose.
6. Fill radiator completely with 50/50 mixture of
ethylene glycol and water. Total system capacity
is 5.4 gallons (20,4 liters). Add coolant to over-
flow bottle until bottle is 1/2 to 3/4 full [approxi-
mately - 2 quarts (1,9 liters)]. This "overfilling"
will compensate for any air in the cooling system.
7. Remove rear radiator cover to access to radiator.
Clean dirt and debris from radiator fins and core.
8. Start engine and run vehicle to normal operating
temperature. Allow engine to cool to ambient
temperature. Check radiator coolant level and
top off completely. Replace radiator cap. Over-
flow bottle should be 1/4 to 1/2 full. If it is not,
add coolant to overflow bottle.
CYLINDER BLOCK
DRAIN PLUG
4. Engine Oil and Filter
A. Level Check (Daily or 10 Hour Intervals)
1. Level the vehicle, ground the carriage, place the
travel select lever in (N) Neutral, engage the
emergency brake switch and shut off the engine.
2. Unlock and open right rear engine access door.
3. Remove dipstick (Figure 27) and check mark on
dipstick (Figure 30). Oil should be between the full
and add mark. With Cummins engines, oil should
be in the crosshatched area of dipstick.