transfer carriage rollers and wear pads, Transfer carriage rear wear pad check, 50 hour intervals) – Lull 944E-42 Operation Manual User Manual
Page 165: Leave the transfer carriage completely retracted, Transfer carriage rollers and, Wear pads, General maintenance, Transfer carriage rollers and wear pads
General Maintenance
163
Model 944E
Origin 3/04
Transfer Carriage Rear
Wear Pad Check
(50 Hour Intervals)
NOTE: The attachment should
remain attached to the quick attach
for these checks.
1. Park the vehicle on level ground. Place the travel select lever in the (N)
NEUTRAL DETENT position, engage the parking brake switch and raise
the boom to a horizontal (level) position.
2. Leave the transfer carriage completely retracted.
3. Fully extend the boom. The attachment must remain slightly off the ground.
Turn the vehicle OFF.
4. At the rear of the transfer carriage, use a feeler gauge to check the gap (6)
between the wear pads (7) and the top of the rail (8). This gap should not
be more than .06" (1,5 mm). If the gap is greater than .06" (1,5 mm) the
wear pads require shimming.
NOTE: Additional shims are available by contacting your local Lull Distributor.
5. Check the thickness of the wear pads. The wear pad has a total thickness
of .75" (19 mm). When the wear pad is worn down to .5" (13 mm) the pads
should be replaced.
19. Transfer Carriage Rollers and Wear Pads
OU0830
50
OH2680
OU0950
8
7
6