Lull 944E-42 Operation Manual - Manual (Page 5)

Safety Practices
3 Model 944E Origin 3/04
JLG reserves the right to make changes on and to add improvements upon its
products at any time without public notice or obligation. JLG also reserves the right
to discontinue manufacturing any product at its discretion at any time.
NOTICE: Under OSHA rules, it is the responsibility of the employer to provide
operator training. Successful completion and certification of Safety Training for
Rough Terrain Forklifts is required. Operator Training Kits are available by calling
Ken Cook Company at (414) 466-6060. An order form for these kits is available
through our website, http://www.jlg.com.
The information in this manual does not replace any safety rules and laws used in
your area. Before operating this vehicle, learn the rules and laws for your area. Make
sure the vehicle has the correct equipment according to these rules and laws.
Your safety and the safety of others in the worksite depend significantly upon your
knowlege and understanding of all correct operating practices and procedures for
this vehicle.
Safety Practices
This safety alert symbol is used with the following signal words to attract your
attention to messages found within the manual and on hazard decals located on the
vehicle. They are reproduced herein and pertain to proper operation and procedure
messages contained throughout the manual. The message that follows the symbol
contains important information about Safety. To avoid possible death or serious
personal injury, carefully read and follow the messages! Be sure to fully understand
the potential causes of death or injury.
Disclaimer
WARNING:
DO NOT modify or alter (weld, drill, etc.) any part of
this vehicle without consulting JLG. Modifications can weaken the struc-
ture creating a hazard that can cause death or serious personal injury.
Hazard Classification System
OP0330