Lull 944E-42 Operation Manual - Manual (Page 28)

26 Model 944E Origin 3/04
Operation
Accelerator Pedal
Pressing down the accelerator pedal (1) increases engine speed and the speed of
the hydraulic system. The pedal is spring-loaded to return to idle speed.
NOTE: The accelerator pedal is also used to activate the Cummins ECM diagnostic
system. With the ignition switch in the RUN position, depress and release the pedal
3 times to activate the system.
Service Brake Pedal
Pressing down the brake pedal (2) decreases the speed of the vehicle by applying
the service brakes located in the axles. In the event of engine power loss, the
service brake pedal can also be used for braking. It also activates and locks the rear
axle to frame lock system when the boom angles are greater than 40 , as long as
the pedal is depressed.
Steering Wheel
Turning the steering wheel (3) to the left or right steers the vehicle in the
corresponding direction. Any one of the steering modes are selectable. Refer to
ìSteering Mode Selectorî on page 27.
Horn Button
Pressing the horn button (4) located in the center of the steering wheel sounds the
horn.
Operator Controls
2
1
3
4
OU0361