Lull 944E-42 Operation Manual - Manual (Page 27)

Operation
25 Model 944E Origin 3/04
Seat Belt
IMPORTANT! Inspect the seat belt every time it is used, looking for cut or worn
webbing, or any defect in the latch assembly. If any wear or damage is noted, DO
NOT operate the vehicle until the seat belt is replaced.
Before the engine is started, adjust the seat as required for position and comfort.
Then adjust the seat belt as follows:
1. Grasp the retractable end of the belt or the male end of the seat belt and
make certain that the belt webbing is not twisted or entangled in any por-
tion of the seat assembly.
2. With your back straight in the seat, couple the retractable end or the male
end of the belt into the receptacle (buckle) end of the belt.
3. With the belt as low on your body as possible, pull the retractable end of
the belt or the free end of the belt away from the buckle until it is tight
across the lap.
4. To release the belt latch, depress the red button (5) and pull the free end
(6) from the buckle.
An optional 3 inch wide seat belt is available for those locations that require a 3 inch
seat belt.
WARNING:
Serious bodily injury or death may result from failure
to wear the seat belt installed on this vehicle. The seat belt is a critical
component of the Operatorís Protective Structure, and is provided for the
operators protection in case of vehicle upset. The seat belt MUST be
worn whenever this vehicle is operated.
OM0720
5
6