Lull 944E-42 Operation Manual - Manual (Page 91)

Operation
89 Model 944E Origin 3/04
This vehicle is designed to lift and transport materials and should not be used to
elevate personnel except as explained in this section. Only equipment designed and
approved for elevating personnel should be used.
If the vehicle must be used to elevate personnel, use only a compliant work platform.
Refer to ìDefining Platforms For Elevating Personnelî on page 89 for requirements.
When using a work platform, the following precautions must be taken:
Defining Platforms For Elevating Personnel
The requirements for platforms shall include the following:
1. The platform floor must have a slip resistant surface not more than
8" (200 mm) above the normal load supporting surface of the forks.
2. The platform floor dimensions shall not exceed:
a. Two times the load center distance as listed on the load chart that is
attached to the vehicle or shown in the ìLoad Chartî section at the end
of this manual. This floor dimension is measured parallel to the longitu-
dinal center plane of the vehicle.
b. Width of the platform shall not be wider than the width of the vehicle,
measured across the load bearing tires plus 10" (250 mm) on each
side.
c. Minimum space requirements for each person on the platform shall not
be less than 18" (450 mm) in either direction.
3. The platform shall have a 4" (100 mm) minimum high toe plate around the
perimeter of the platform. The toe plate may be omitted at the access open-
ing.
4. Protection must be provided for the personnel on the work platform from
any pinch points or moving parts while in their normal working position on
the platform.
5. Information prominently indicated on the work platform shall include:
a. Maximum work load including personnel and equipment.
b. Weight of the empty platform.
6. Provide a means to securely mount and attach the platform so it can:
a. Only be centered laterally on the vehicle and retained against the verti-
cal face of the forks, carriage or the lifting mechanism.
b. Prevent the platform from inadvertent pivoting.
Elevating Personnel
WARNING:
Use only a compliant work platform to lift or lower
personnel. Never drive the vehicle with the work platform in a raised posi-
tion or with personnel on board, even for a short distance.