ElmoMC SimplIQ Servo Drives Composer User Manual - Manual (Page 46)

Remember:
ƒ You can remove bookmarks using the Clear All Bookmarks option from
the right-click shortcut menu.
ƒ You can also automatically accept all rows of the table by selecting the
Accept ALL option from the shortcut menu. (Use Clear All Accepts to
remove all checks.)
4. To modify the gain schedule table further, repeat steps 2 and 3 as necessary.
5. To save your final gain schedule table, click Save GS Table. In the Save As dialog
box, enter a name for the file, browse to the location at which it should be saved, and
click Save. The system will save the table, along with its bookmarks.
2.12 Saving Your Application
Upon completion of your last tuning step, the Setup Information dialog box will be
displayed, as in the following example:
This final dialog box lists all the parameters that were modified during the Wizard auto-
tuning session. You may scroll through the parameters in the list at the left or you can
open the Application Editor (explained fully in
section 3.6 ) to view them as needed.
To finalize your new or modified application:
1. Click Application Editor if you wish to view the full set of application parameters in
the Composer Application Editor. A standard Save As dialog box will be displayed
for entering the path and file name for saving the file. The Application Editor will
then be opened in read-only mode.
2. To change any of the application parameters, click Back to return to the previous
Wizard process. Continue to click Back until you reach the tuning stage in which the
parameter(s) need to be changed.
Composer User Manual Using the Wizard
MAN-COMPUM (Ver. 1.9)
2-5