HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System User Manual
Page 15
To set up a parameter:
1) Select one of the Parameter
Profile by tapping the button on the right side of the screen to toggle between the choices.
Note: Torque Control
Angle Control Profile Parameters
2) Select the direction of rotation for the parameter by toggling between ‘clockwise’ and
‘counterclockwise’ at the top of the screen.
3) Select the torque units by selecting the
selecting the units required.
4) Name the parameter by selecting the button below the yellow
screen keypad to enter the desired name.
5) Fill out the rundown characteristics by
keypad to enter the information.
6) Tap the yellow [<<] button to return to the parameter list and select ‘Yes’ to save the changes.
Page 15
Parameter buttons and select either Torque Control Profile or Angle Control
by tapping the button on the right side of the screen to toggle between the choices.
Torque Control Profiles Parameters will appear in BLUE on the parameter list and
Profile Parameters will appear in GREEN.
direction of rotation for the parameter by toggling between ‘clockwise’ and
‘counterclockwise’ at the top of the screen.
Select the torque units by selecting the button at the top right hand corner of the screen, then
selecting the units required.
Name the parameter by selecting the button below the yellow [<<] button and using the on
screen keypad to enter the desired name.
Fill out the rundown characteristics by tapping on the underlined areas and using the on
keypad to enter the information.
button to return to the parameter list and select ‘Yes’ to save the changes.
or Angle Control
by tapping the button on the right side of the screen to toggle between the choices.
on the parameter list and
direction of rotation for the parameter by toggling between ‘clockwise’ and
button at the top right hand corner of the screen, then
button and using the on-
tapping on the underlined areas and using the on-screen
button to return to the parameter list and select ‘Yes’ to save the changes.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440