Safety precautions – HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System User Manual
Page 5
Safety Precautions
Be sure to read all instructions and precautions contained in this manual, failu
result in personal injury and/or damage to tooling and components.
Do not operate or plug in the controller/system with wet hands or in wet environments.
Failure to observe this may result in injury due to electric shock.
Ensure the controller is properly plugged in to a grounded electrical receptacle. Do not remove
the ground pin or use any adapter plugs.
Always shut down the controller when changing cables or tools. Failure to do so could damage
the tool or controller.
Keep work area clear of clutter and distractions that may cause the operator to lose control of
the tool or the components.
Tool cable must be properly routed and festooned to avoid tangling and trip hazards.
Always use safety glasses when using electrical
Do not use any part of the system (tool, cable, or controller) for anything other than its
specified application. Use of the system or its components for unintended applications could result in
injury to the operator, failure of the sy
Never modify or disassemble any component of the system. Modification or disassembly of the
system could result in injury and void the warranty.
Page 5
Be sure to read all instructions and precautions contained in this manual, failu
result in personal injury and/or damage to tooling and components.
Do not operate or plug in the controller/system with wet hands or in wet environments.
Failure to observe this may result in injury due to electric shock.
roller is properly plugged in to a grounded electrical receptacle. Do not remove
the ground pin or use any adapter plugs.
Always shut down the controller when changing cables or tools. Failure to do so could damage
ork area clear of clutter and distractions that may cause the operator to lose control of
Tool cable must be properly routed and festooned to avoid tangling and trip hazards.
Always use safety glasses when using electrical assembly tools.
Do not use any part of the system (tool, cable, or controller) for anything other than its
specified application. Use of the system or its components for unintended applications could result in
injury to the operator, failure of the system, and could void the warranty.
Never modify or disassemble any component of the system. Modification or disassembly of the
system could result in injury and void the warranty.
Be sure to read all instructions and precautions contained in this manual, failure to do so may
Do not operate or plug in the controller/system with wet hands or in wet environments.
roller is properly plugged in to a grounded electrical receptacle. Do not remove
Always shut down the controller when changing cables or tools. Failure to do so could damage
ork area clear of clutter and distractions that may cause the operator to lose control of
Tool cable must be properly routed and festooned to avoid tangling and trip hazards.
Do not use any part of the system (tool, cable, or controller) for anything other than its
specified application. Use of the system or its components for unintended applications could result in
Never modify or disassemble any component of the system. Modification or disassembly of the
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440