Task setup, Renaming and importing tasks – HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System User Manual
Page 18
Page 18
Task Setup
From either the ‘Run Tool’ or ‘Setup’ screens, tapping the task name will bring up the ‘Task Setup’
screen shown below:
All 12 tasks are displayed here and tapping any one will switch to that task.
Renaming and Importing Tasks
From the ‘Task Setup’ menu, pressing and holding on a task name will display the following screen:
Tapping the ‘Rename’ button will allow the user to enter a customized name with the on-screen keypad.
When a USB drive is inserted, the ‘Import’ button will be active, allowing the user to select a task file to
import from the USB drive. The task settings from the imported file will completely over-write the
task shown at the top of this screen, there is no partial import.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440