Data screen – HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System User Manual
Page 32
Data Screen
For data traceability, rundown information is stored in table form for view and download from the
controller. To access this data, tap the ‘Data’ button on the bot
100 rundowns since the last controller reboot is available to view on screen.
on screen is:
• Date/Time
• Bolt Number
• Result (Good, High Torque, Low Angle, etc)
• Tool Cycle
• Target Torque/Angle
• Prevailing Torque
• Applied Torque (Sum of Final Torque a
• Final Torque
• Final Angle
To page through the on-screen data, use the ‘Next’ and ‘Previous’ buttons available at the bottom of the
screen.
An expanded data set is stored in the controller’s internal memory, the number of rundowns s
limited only by the memory of the controller, and once filled is replaced in a first in/first out basis.
Refer to the ‘Downloading Data’ section of this manual for more information on how to retrieve this
data.
NOTE: Turning off the controller will clear the table of all data. The data is retained in memory
for download, but will not be available
Page 32
For data traceability, rundown information is stored in table form for view and download from the
controller. To access this data, tap the ‘Data’ button on the bottom of the ‘Run Tool’ screen.
e the last controller reboot is available to view on screen. The data available to view
Result (Good, High Torque, Low Angle, etc)
Applied Torque (Sum of Final Torque and Prevailing Torque)
screen data, use the ‘Next’ and ‘Previous’ buttons available at the bottom of the
An expanded data set is stored in the controller’s internal memory, the number of rundowns s
limited only by the memory of the controller, and once filled is replaced in a first in/first out basis.
section of this manual for more information on how to retrieve this
urning off the controller will clear the table of all data. The data is retained in memory
for download, but will not be available for on-screen viewing.
For data traceability, rundown information is stored in table form for view and download from the
tom of the ‘Run Tool’ screen. The last
The data available to view
screen data, use the ‘Next’ and ‘Previous’ buttons available at the bottom of the
An expanded data set is stored in the controller’s internal memory, the number of rundowns stored is
limited only by the memory of the controller, and once filled is replaced in a first in/first out basis.
section of this manual for more information on how to retrieve this
urning off the controller will clear the table of all data. The data is retained in memory
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440