Output programming – HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System User Manual
Page 25
Output Programming
There are (8) programmable outputs, 24V DC, and ground
connector on the bottom of the controller. See the chart at the end of this section for pin location and
other technical information. All the outputs can be set up with the following instructions from the ‘Run
Tool’ Screen:
• Tap the ‘Setup’ Button
o Make sure the task shown at the top is the one to be programmed.
• Tap the ‘Outputs’ Button
Select an available output button by tapping the ‘none’ button. Under the ‘Event’ heading, select the
appropriate radio button. Select the type of output you would like under the ‘Behavior’ heading, and if
necessary input the time intervals for the non
enter the value you wish on the on-
will appear in red until they are saved by exiting the screen with the yellow
Note: Back on the ‘Outputs’ screen
your device by tapping the ‘Test’ button next to each output.
AVAILABLE OUTPUT CRITERIA:
• BOLT - SUCCESS: (All torque and angle requirements fall within the predefined acceptable
ranges of the programmed parameter)
• BOLT – FAIL LOW: (Any torque or angle requirement fell below the predefined acceptable
ranges of the programmed parameter)
• BOLT – FAIL HIGH: (Any torque or angle requirement fell above the predefined acceptable
ranges of the programmed
• BATCH ACCEPT: (All bolts or cycles required in the task are complete and within the acceptable
ranges)
Page 25
outputs, 24V DC, and ground supply available through the output
connector on the bottom of the controller. See the chart at the end of this section for pin location and
All the outputs can be set up with the following instructions from the ‘Run
Make sure the task shown at the top is the one to be programmed.
button by tapping the ‘none’ button. Under the ‘Event’ heading, select the
appropriate radio button. Select the type of output you would like under the ‘Behavior’ heading, and if
necessary input the time intervals for the non-solid outputs. To adjust these values, tap on the number,
-screen keypad, then tap the enter button. Any un-
will appear in red until they are saved by exiting the screen with the yellow [<<] button.
Back on the ‘Outputs’ screen, you will have the opportunity to test the output signal to
by tapping the ‘Test’ button next to each output.
: (All torque and angle requirements fall within the predefined acceptable
grammed parameter)
: (Any torque or angle requirement fell below the predefined acceptable
ranges of the programmed parameter)
: (Any torque or angle requirement fell above the predefined acceptable
ranges of the programmed parameter)
: (All bolts or cycles required in the task are complete and within the acceptable
available through the output
connector on the bottom of the controller. See the chart at the end of this section for pin location and
All the outputs can be set up with the following instructions from the ‘Run
button by tapping the ‘none’ button. Under the ‘Event’ heading, select the
appropriate radio button. Select the type of output you would like under the ‘Behavior’ heading, and if
ese values, tap on the number,
-saved changes
button.
, you will have the opportunity to test the output signal to
: (All torque and angle requirements fall within the predefined acceptable
: (Any torque or angle requirement fell below the predefined acceptable
: (Any torque or angle requirement fell above the predefined acceptable
: (All bolts or cycles required in the task are complete and within the acceptable
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440