Controller information, Firmware update – HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System User Manual
Page 39
Controller Information
To view basic information about the controller and to give the controller a name, tap the ‘Controller
Info’ button on the ‘System’ screen. This screen displays the following:
• Controller Name
• Controller Serial Number
• GUI Board Firmware Version
• Controller Board Firmware Version
Changing the Controller Name: To change the controller name, tap the button on the ‘Controller
Information’ screen that shows the current name,
NOTE: When exporting data to a USB flash drive from the controller, the name of the folder
created on that flash drive will be the same name as the controller. This will assist the user if
downloading data from multiple controllers onto one single flash drive. See the Data Scre
more information on downloading data to USB.
Firmware Update
When a USB flash drive is inserted to the controller, the ‘Firmware Update’ buttons are active on the
‘Controller Information’ screen. Tapping
select a file to upload to the controller. The firmware file can be obtained from ASG, contact ASG
Customer Service for more information and eligibility.
The USB flash drive must be FAT32 formatted for this feature to work pro
a properly formatted flash drive can result in firmware corruption and require the controller to be
serviced at ASG to reset it to proper function.
Page 39
To view basic information about the controller and to give the controller a name, tap the ‘Controller
Info’ button on the ‘System’ screen. This screen displays the following:
ion
Controller Board Firmware Version
To change the controller name, tap the button on the ‘Controller
Information’ screen that shows the current name, and then enter the new name on the screen.
a to a USB flash drive from the controller, the name of the folder
created on that flash drive will be the same name as the controller. This will assist the user if
downloading data from multiple controllers onto one single flash drive. See the Data Scre
more information on downloading data to USB.
When a USB flash drive is inserted to the controller, the ‘Firmware Update’ buttons are active on the
‘Controller Information’ screen. Tapping the button will allow you to navigate to the flash drive and
select a file to upload to the controller. The firmware file can be obtained from ASG, contact ASG
Customer Service for more information and eligibility.
The USB flash drive must be FAT32 formatted for this feature to work properly. Failure to use
a properly formatted flash drive can result in firmware corruption and require the controller to be
serviced at ASG to reset it to proper function.
To view basic information about the controller and to give the controller a name, tap the ‘Controller
To change the controller name, tap the button on the ‘Controller
enter the new name on the screen.
a to a USB flash drive from the controller, the name of the folder
created on that flash drive will be the same name as the controller. This will assist the user if
downloading data from multiple controllers onto one single flash drive. See the Data Screen section for
When a USB flash drive is inserted to the controller, the ‘Firmware Update’ buttons are active on the
e to the flash drive and
select a file to upload to the controller. The firmware file can be obtained from ASG, contact ASG
perly. Failure to use
a properly formatted flash drive can result in firmware corruption and require the controller to be
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440