Date/time settings, Tool trigger sensitivity – HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System User Manual
Page 37
Page 37
Date/Time Settings
To set the controller’s date and time, tap the ‘Date/Time’ button on the ‘System Setup’ screen. Adjust
the date and time with the up and down arrow keys above and below each number. Note: the time is
formatted in a 24 hour format, and the date is in MM/DD/YY format. Tap the [<<] button to return to
the previous screen and save changes.
Tool Trigger Sensitivity
The controller allows the user to set the sensitivity of both the Push-to-Start and the Lever Start (when
equipped) features of the ASG-SD2500 tool to suit individual user or application preferences. To adjust
these settings, tap the ‘Tool Trig Sensitivity’ button on the ‘System’ screen.
On the ‘Trigger Sensitivity’ screen there are two slider bars, one for the Lever, and one for the Push-to-
Start. On each slider there is the following:
• Yellow bar – shows the minimum trigger reading
• Red bar – shows the maximum trigger reading
• White bar – shows the current trigger reading
• Green bar - shows the trigger reading threshold
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440