HYDAC HMG 3010 - Manual (Page 30)

HMG 3010 Page 30
Edition 11/2011 - V04 R01 Part No.: 669855
The screenshots on the right show the
measured values of four sensors when the
2 display panels option is selected and the
Min/Max display is activated. Consequently,
the display only shows the measured values
of two sensors at a time. Use the arrow keys
(▲) and (▼) to see the measured values of
the other two sensors.
In order to display the measured values of
4 sensors simultaneously, you need to se-
lect the 2x2 display panels option (cf.
screenshot).
In the third line of the Display settings
menu there is a Yes/No option next to Show
progress bar. When Yes is selected, the
progress bar is also shown in the measured
value display. The appearance of the display
may vary according to what settings have
been made for rendering the measured val-
ues.
The overall width of the particular progress
bar corresponds to 0 ... 100% of the meas-
urement range. The progress bar shows the
position of the actual measured value in the
overall measurement range. Showing the
Min/Max values causes the display to be
altered. The current measured value is now
shown by a dot and the length of the pro-
gress bar shows the range from Min to Max.
No switches off the progress bar.
Back takes you back to the Settings menu.