HYDAC HMG 3010 - Manual (Page 55)

HMG 3010 Page 55
Edition 11/2011 - V04 R01 Part No.: 669855
Start-Stop Measurement
The Start-Stop Measurement option allows
you to start a recording when triggered by a
defined condition and to stop it again when
triggered by a second defined condition.
If the stop condition does not occur within
the pre-set recording time, then the re-
cording will stop after the specified time has
elapsed.
Example of a Start-Stop Measurement:
Under Trigger 1 (Start) and Trigger 2
(Stop) select the relevant start and stop
condition and confirm with OK.
Under Recording time, define the time at
which the measurement must stop automati-
cally if the Trigger-Condition 2 (Stop) has not
occurred by then.
With Automatic mode you define whether
you wish to make just one measurement
(Deactivated) or whether, after recording
one measurement curve, another curve is to
be recorded using the same settings (Acti-
vated).
Zoomed area
With the "zoomed area", an additional dis-
play area can be created during the re-
cording in the graphic mode.
In other words, with the Magnifier setting,
the x-axis is scaled to the time span preset in
this menu point (5 seconds / 10 seconds /
...).
(The setting options for the zoomed area are
dependent on the preset sampling rate and
the specified recording time.)