JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 123)

123
9 Program editor
Channel 1 to Channel 3 (Selection of the channel to be programmed)
Channel name Channel 1 (Channel 2, Channel 3)
Enter channel names
(max. 14 characters).
The default setting depends on the
channel selected.
Free choice of name for the program
channel
A program channel is only valid if it has
been assigned a name.
Use the ">" button to open a window in
which the text can be entered in up to
four national languages.
Cut Select the button Use this button to cut lines (program
sections) that have been marked.
Copy Select the button Use this button to copy lines (program
sections) that have been marked.
Insert Select the button Use this button to insert lines (program
sections) that have been cut or copied
above a selected line.
Add empty
line
Select the button Use this button to insert an empty line
above a marked line (program section).
Delete Select the button Use this button to delete lines (program
sections) that have been marked.
No. Select section from 1 to 100 to be pro-
grammed (starting with section 1) Number of program section
Section time 0 to 360000 s
(Max. 59:59:59 hh:mm:ss)
Length of program section
Up to 100 program sections can be
defined in a program channel.
A program channel is only valid if at
least one of the program sections has a
section time of
> 0 s.
RS
(Repeat section
1 to 100 Number of program section that is to be
repeated with the following section.
NoC
(Number of
cycles)
0 to 99 Number of repetitions of a program sec-
tion (or multiple linked program sec-
tions)
Setpoint 1 to 4 -99999 to 0 to +99999
The limits depend on the minimum and
maximum admissible setpoint values 1
to 4 of the program generator.
Setpoint value 1 to setpoint value 4
Tol low
(Lower limit of tol-
erance band)
-99999 to 0 to +99999
The limits depend on the minimum and
maximum admissible lower limit of the
tolerance band for the program genera-
tor.
Lower limit value for tolerance band
monitoring of setpoint value 1
Parameter Selection/settings Description
?
?
?