JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 126)

9 Program editor
126
RS, NoC
The program sections to be repeated form a repeat cycle. The number of cycles (NoC) and the
start of the repeat section (RS) are programmed in the last program section of a repeat cycle.
Example:
Program sections 2 to 4 are repeated once. Therefore, the following settings must be made in
section 4:
NoC (number of cycles) = 1
RS (repeat section) = 2
Program profile
The following diagrams show the progression of a setpoint value within a program section, if
"Step" or "Ramp" is specified for the setpoint input (generator configuration parameter).
The programmed setpoint value determines the setpoint value at the start of the relevant pro-
gram section.
If "Step" is specified for the setpoint input, the setpoint value remains constant in the program
section. It does not change until the next section that has been programmed with a different
setpoint value starts.
If "Ramp" is specified for the setpoint input and the next section has been programmed with a
different setpoint value, the setpoint value follows a ramp course within the program section.
The ramp slope is determined by the section time and the difference between the two setpoint
values.
1 to 6 Program sections C Repeat cycle
1 3 3 2 2 4 4 5 6
w
t
C
S1 Program section 1 w1 Setpoint value in program section 1
T1 Section time 1 w2 Setpoint value in program section 2
S1
w
T t
w1
w2
1
S1
w
w1
T1 t
w2