JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 91)

91
6 Configuration
Start program Program start Program starts at the first programmed
setpoint value.
Actual value The actual value of program channel 1
is adopted as the first setpoint value. All
other channels run synchronously from
this point in time.
Time A start time specified for program start is
adopted as the start time in a 24 h pro-
gram.
Example:
Start time: 06:00:00; 24 h program from
00:00 to 24:00: The program starts at 6
a.m. and runs until midnight.
Behavior at
O-o-R
Behavior of the program generator if measurement range is exceeded or if there is
measuring range underflow (Out-of-Range)
Continuous operation Program continues to run.
Program stop Program is stopped.
Power off Behavior of the program generator when the power failure is over.
Abort Program is aborted; the program gener-
ator enters basic status.
Continuous operation Program continues running to the point
that it was at when the power failed.
Standstill Program is stopped; the program gener-
ator enters basic status.
The program can be set to continue or
abort.
Proceed at x % If the difference of the actual value
before and after the power failure is
below or equal to x %, the program con-
tinues running to the point that it was at
when the power failed. If this is not the
case, the program generator enters
standstill.
Proceed at actual value The program continues running at the
actual value; consideration is given to
whether the program profile had a posi-
tive or negative trend at the time of the
power failure.
Actual value dif-
ference 0 to 100 % The maximum admissible difference
between the actual value before and
after the power failure for the program to
continue running.
Start with time The program can be started at a specific time (entry of date and time during oper-
ation).
No Immediate program start (e.g. by opera-
tion or digital signal)
Yes Program start at a specific time
Parameter Selection/settings Description
?