Lenze Loader L-force Loader - Manual (Page 22)

L-force Loader
Operation
How to select files for the download
22 DMS 4.0 EN - 07/2007
L
5.4.2 How to open application data
If the target system supports the download of application data, click Application data... to
open an application data file for the download.
r After this, you can download *.lc9 files containing motion profiles & cam data created
with Cam Designer or *.lc7 files created with GDC to the target system.
r Apart from *.lc9-/*.lc7 files you can open any other files for the download, provided that
they have the file header specified by Lenze.
– Detailed information about the structure of the file header can be found in the
Manual for the 9300 Servo PLC (6.x), chapter "Appendix / Memory / Download of any
data".
M
How to open an application data file...
1. Select Application data... in the function area.
2. Select the desired file in the Open application data dialog box.
3. Click OK to confirm your selection.
• The selection is accepted and the dialog box is closed.
r If the application data could be opened properly,
– the Close application data function will be available instead of the Application
data... function. Use this function to close the application data.
– the Download... function will be provided to download the file(s) to the target
system.
– the dialog area will display information about the opened application data in the
Application data tab.
r If it is not possible to open the application data properly, an error message with an error
number will be displayed.  Error numbers, causes & remedies
(C 36)
Next steps:

How to open a DDS binary file
(C 21)
/

How to open a GDC parameter set file
(C 23)
or
 How to download data
(C 25)