Safety information – Multiquip LS-600P User Manual

Page 10

Advertising
background image

page 10 — MaYCO LS600p CONCReTe pUMp • OpeRaTiON MaNUaL — Rev. #0 (05/13/13)

SAfEty InfORMAtIOn

TRaNSpORTiNg SafeTY

CaUTiON

„

NeveR allow any person or animal to stand underneath

the equipment while lifting.

NOTICE

„

Before lifting, make sure that the equipment parts are not

damaged and screws are not loose or missing.

„

ALWAYS make sure forklift forks are inserted into pockets

(if applicable) as far as possible when lifting the pump.

„

ALWAYS shutdown engine before transporting.

„

NeveR lift the equipment while the engine is running.

„

Tighten fuel tank cap securel to prevent fuel from spilling.

„

Use one point suspension hook and lift straight upwards.

„

DO NOT lift machine to unnecessary heights.

„

ALWAYS tie down equipment during transport by

securing the equipment with straps, rope or chains.

TOWiNg SafeTY

CaUTiON

„

Check with your local county or state safety

towing regulations, in addition to meeting

Department of Transportation (DOT)

Safety Towing Regulations, before towing

your generator.

„

In order to reduce the possibility of an accident while

transporting the generator on public roads,

ALWAYS

make sure the trailer that supports the pump and the

towing vehicle are mechanically sound and in good

operating condition.

„

ALWAYS shutdown engine before transporting

„

Make sure the hitch and coupling of the towing vehicle

are rated equal to, or greater than the trailer “gross

vehicle weight rating.”

„

ALWAYS inspect the hitch and coupling for wear. NeveR

tow a trailer with defective hitches, couplings, chains, etc.

„

Check the tire air pressure on both towing vehicle and

trailer.

Trailer tires should be infl ated to 80 psi cold.

Also check the tire tread wear on both vehicles.

„

ALWAYS make sure the trailer is equipped with a safety

chain.

„

ALWAYS properly attach trailer’s safety chains to towing

vehicle.

„

ALWAYS make sure the vehicle and trailer directional,

backup, brake and trailer lights are connected and

working properly.

„

DOT Requirements include the following:

• Connect and test electric brake operation.
• Secure portable power cables in cable tray with tie

wraps.

„

The maximum speed for highway towing is

55 MpH unless

posted otherwise. Recommended off-road towing is not

to exceed

15 MpH or less depending on type of terrain.

„

Avoid sudden stops and starts. This can cause skidding,

or jack-knifi ng. Smooth, gradual starts and stops will

improve towing.

„

Avoid sharp turns to prevent rolling.

„

Trailer should be adjusted to a level position at all times

when towing.

„

Raise and lock trailer wheel stand in up position when

towing.

„

Place

chock blocks underneath wheel to prevent rolling

while parked.

„

Place

support blocks underneath the trailer’s bumper

to prevent

tipping while parked.

„

Use the trailer’s swivel jack to adjust the trailer height to
a level position while parked.

Advertising