Multiquip LS-600P - Manual (Page 28)

page 28 — MaYCO LS600p CONCReTe pUMp • OpeRaTiON MaNUaL — Rev. #0 (05/13/13)
The engine (Figure 8) must be checked for proper
lubrication and filled with fuel prior to operation. Refer
to the manufacturer's engine manual for instructions and
details of operation and servicing.
1.
Crankshaft pulley — Check fan V-belt between
V-Pulley and alternator to determine proper belttension.
2. Water Pump — Circulates coolant flow through engine
block.
3. v-Belt — Driven by the engine crankshaft during
operation, drives the water pump/fan as well as the
alternator.
4. Alternator — Provides power to the electrical system.
Replace with only manufacturer's recommended
replacement parts.
5. front/Rear Lifting eye — When lifting of the engine
is required attach a strap or chain of adequate lifting
capacity to these lifting points.
6. Oil filler port/Cap –— Remove this cap to add engine
oil to the crankcase. Fill with recommended type of oil
as specified in the maintenance section of this manual
7. Air Cleaner — Prevents dirt and other debris from
entering the fuel system. Remove clamps on air filter
canister to gain access to filter element. Replace with
only manufacturer's recommended type air cleaner.
8. air intake port — Attach the air filter hose to this port.
9. Secondary Fuel Filter — Prevents dirt and other
debris from entering the fuel system. Service the fuel
filter as recommended in the maintenance section of
this manual.
10. fuel injection pump — Provides equal fuel flow to
injectors.
11. Oil Filter — Spin-on type, filters oil for contaminants.
12. Flywheel — A rotating gear attached to a driveshaft.
13. Muffler — Used to reduce noise and emissions. DO
NOT touch muffler when engine is running. Allow
muffler to cool before performing maintenance.
14. Turbocharger — Provides pressurized intake air to the
cylinder by means of a turbine energized by exhaust
gas that rotates the blower.
15. Dip Stick — Remove dipstick to determine if the engine
oil level is low. If low, add oil as specified in Table 4.
16. Oil Pan — Reservoir for engine oil. Capacity is 2.08
gallons (2.5 liters).
17. Starter/Solenoid — This engine uses a 12VDC, 2.7kW
(3.7 HP) starter motor with solenoid.
18. Oil Drain plug (2) — Remove to drain crankcase
oil. Always dispose of used oil and oil filters in an
environmentally safe manner. DO NOT allow used oil
to drain onto the ground or into a water runoff drain.
19. Primary Fuel Filter — Prevents dirt and other debris
from entering the fuel system. Service the fuel filter
as recommended in the maintenance section of this
manual.
Figure 8. Perkins 1104D-44TA Diesel Engine Components
12
14
15
16
17
18
19
2
4
5
6 4
3
9
11
8
1
7
10
13
EnGInE cOMPOnEntS