Trailer guidelines – Multiquip LS-600P User Manual

Page 64

Advertising
background image

page 64 — MaYCO LS600p CONCReTe pUMp • OpeRaTiON MaNUaL — Rev. #0 (05/13/13)

TiRe SafeTY

Unsafe Tires, Lug Nuts or Wheels

Trailer tires and wheels are more likely to fail than car tires

and wheels because they carry a heavier load. Therefore,

it is essential to inspect the trailer tires before each tow.
If a tire has a bald spot, bulge, cuts, is showing any cords,

or is cracked, replace the tire before towing. If a tire has

uneven tread wear, take the trailer to a dealer service

center for diagnosis.
Uneven tread wear can be caused by tire imbalance, axle

misalignment or incorrect infl ation.
Tires with too little tread will not provide adequate tracking

on wet roadways and can result in loss of control, leading

to death or serious injury.
Improper tire pressure causes an unstable trailer and

can result in a tire blowout and loss of control. Therefore,

before each tow you must also check the tire pressure. Tire

pressure must be checked when tires are cold.
Allow 3 hours cool-down after driving as much as 1 mile at

40 mph before checking tire pressure. Trailer tires will be

infl ated to higher pressures than passenger vehicle tires.
Since trailer wheels and lug nuts (or bolts) are subjected

to greater side loads than automobile wheels, they are

more prone to loosen. Before each tow, check to make

sure they are tight.
The proper tightness (torque) for lug nuts is listed in the

lug nut tightening section of this manual. Use a torque

wrench to tighten the lug nuts. If you do not have a torque

wrench, use a lug wrench (from your tow vehicle) and

tighten the nuts as much as you can. Then have a service

garage or trailer dealer tighten the lug nuts to the proper

torque.

WaRNiNg

Metal creep between the wheel rim and lug nuts will

cause rim to loosen and could result in a wheel coming

off, leading to death or serious injury.
Tighten lug nuts before each tow.

Lug nuts are also prone to loosen after first being

assembled. When driving a new trailer (or after wheels

have been remounted), check to make sure they are tight

after the fi rst 10, 25 and 50 miles of driving and before

each tow thereafter.
Failure to perform this check can result in a wheel parting

from the trailer and a crash, leading to death or serious

injury.

Determining Load Limit of Trailer

Determining the load limits of a trailer includes more than

understanding the load limits of the tires alone. On all

trailers there is a Federal certifi cation/VIN label that is

located on the forward half of the left (road) side of the unit.

This certifi cation/VIN label will indicate the trailer’s Gross

Vehicle Weight Rating (GVWR). This is the most weight

the fully loaded trailer can weigh. It will also provide the

Gross Axle Weight Rating (GAWR). This is the most a the

axle can weigh.

WaRNiNg

Lug nuts are prone to loosen after initial installation,

which can lead to death or serious injury.
Check lug nuts for tightness on a new trailer or when

wheel(s) have been remounted after the fi rst 10, 25

and 50 miles of driving.

WaRNiNg

Improper lug nut torque can cause a wheel parting from

the trailer, leading to death or serious injury.
Be sure lug nuts are tight before each tow.

WaRNiNg

Improper tire pressure can result in a blowout and loss

of control, which can lead to death or serious injury.
Be sure tires are infl ated to pressure indicated on side

wall before towing trailer.

tRAILER GuIDELInES

Advertising