Sensaphone 400 - Manual (Page 44)

42
SENSAPHONE 400 User’s Manual
To erase a Zone or ID message:
1. Press the SENSOR ON/OFF key.
SENSOR
ON/OFF
2. Press the MESSAGE key.
MESSAGE
The 400 will say “Enter message number.”
3. Press the Zone Number or ID key.
0
ID NUMBER
POWER
The 400 will say, “Message erased.”
4 .2 the unIt Id number
The Unit ID Number is the identification number of the Model 400. This
number is typically the telephone number where the unit is installed, or it
may be designated using any number that best suits your application.
The purpose of the Unit ID Number is to immediately provide the source
of any alarm, especially when using multiple Model 400 units in a complex
monitoring system. When the Model 400 is called from a remote location,
it always begins its message with the identification number:
“Hello, this is (Unit ID Number).”
4 .2 .1 programmIng the Id number
To program the ID Number:
1. Press SET.
SET
2. Press ID NUMBER.
0
ID NUMBER
POWER