Sensaphone 400 - Manual (Page 51)

Chapter 4: Communications Programming
49
Code 2 Wait-for-Answer
You can force your Sensaphone to Wait-For-Answer in the middle of dial-
ing a telephone number. This is useful when calling a telephone extension
that is initially answered by an auto-attendant. By inserting the wait-for-
answer code you can instruct your Sensaphone to call the main number,
then wait for an answer by the auto-attendant, then dial the extension.
The Sensaphone will not speak it’s voice message until the telephone is
answered at the extension.
Example:
SET + PHONE NUMBER + any unassigned number key 1-4
+ telephone number + CODE + 2 + extension number + ENTER
Code 3 Switch to Touch-tone
This command allows you to change from pulse dialing to touch-tone dial-
ing in the middle of dialing a telephone number. This is useful when your
telephone service only supports pulse dialing, but you need to send touch-
ones after connecting – such as when dialing a numeric pager or navigating
a voice menu.
Example:
In this example a telephone number is dialed, the Sensaphone waits for the
call to be answered, then changes to touch-tones to dial an extension.
SET + PHONE NUMBER + any unassigned number key 1-4 +
telephone number + CODE + 2 + CODE + 3 +
extension number + ENTER
4 .6 .2 InCorporatIng a pauSe
Incorporate PAUSE to access an outside telephone line:
1. Press SET.
SET
2. Press PHONE NUMBER.
PHONE
NUMBER
T/P