Sensaphone 400 - Manual (Page 49)

Chapter 4: Communications Programming
47
3. Press 0 then ENTER to enter manual dialing mode. The 400 will go
off-hook and you should hear a dial tone through the speaker. Press any
number keys to dial a telephone number.
0
ID NUMBER
POWER
4. Press ALARM CANCEL to hang up and exit the test.
ALARM
CANCEL
4 .5 tone or pulSe dIalIng
The Model 400 can dial out in pulse or Touch Tone™. Select the type of
dialing, in either pulse or tone, depending upon the type of service pro-
vided by your telephone company. The default is tone.
To program for either pulse or tone:
1. Press the SENSOR ON/OFF key.
SENSOR
ON/OFF
2. Press PHONE NUMBER T/P.
PHONE
NUMBER
T/P
The Model 400 will respond: “Tone” to indicate that tone dialing is enabled,
or “Pulse” to indicate that pulse dialing is on and enabled.
3. Repeat key sequence to switch between settings.
4 .6 SpeCIal dIalIng
The Model 400 has provisions for special dialing sequences. Special dialing
sequences allow:
• Dialing that requires an access number to connect with an outside line.
• Dialing that requires the pound (#) or star (*).
• Dialing to a beeper or pager.