Sensaphone 400 - Manual (Page 71)

Chapter 5: Alarm Programming
69
5 .2 enable/dISable ZoneS
This function allows you to enable or disable a zone’s response to an alert
condition. An enabled zone will respond to an alert condition and allow
dial-out. A disabled zone will cause dial-out to be suppressed, but any
existing alert conditions will be revealed during the Status Report. Enable/
disable programming is useful during wiring of zones (see Chapter 2) or
when a condition needs to be monitored, but is not critical enough to be
programmed for dial-out reporting. It is important to verify zone status
after performing any task that requires disabling. The default setting for all
zones is enabled (ON).
If an alert condition exists when zones are re-enabled, Recognition Time
will restart—refer to Section 5.3.
If the sensor is configured as not used, the unit will respond “Error the zone
is off”. Refer to section 5.13 to designate as used.
5 .2 .1 ChangIng enabled/dISabled Zone StatuS
1. Press SENSOR ON/OFF.
SENSOR
ON/OFF
2. Press the number (1 to 4) of the selected zone to enable/disable. The
Model 400 says “Alarm Disabled” to indicate disabled or “Alarm Enabled”
to indicate enabled.
4
MAX CALLS
3
INTERCALL
TIME
1
CALL
DELAY
2
VOICE
REPS
5 .2 .2 verIFyIng enabled/dISabled Zone StatuS
1. Press WHAT IS.
WHAT
IS
2. Press STATUS.
STATUS
The Model 400 audibly recites the current status of every zone. In a Status
Report, each zone is first identified by its zone number, followed by a
report that specifies parameters currently affecting that zone. If a zone
is disabled, the word “Alarm Disabled” immediately follows the number
recited for that zone.