Rockwell Automation 1492-PRINT110_PRINT220 ClearMark Printer User Manual - Manual (Page 20)

2-2 Rockwell Automation Publication 1492-UM008A-EN-P - June 2010
Chapter 2 Initial Set Up
• Quick Start Guide
• ClearMark Printer user manual (this document)
• ClearTools Software user manual
• Printer driver and ClearTools software CD
• Two marker cards (Cat. No. 1492-M5X5)
• Output rail
Set Up Select a suitable location for the ClearMark printer, considering the following
factors:
• Place the ClearMark printer on a flat, stable surface larger than the base
area of the printer.
• The ClearMark printer will not operate properly if it is tilted or at an
angle.
• Ensure there is sufficient space to allow the marker cards to be ejected
without obstruction from the printer.
• Avoid installing the ClearMark printer in any location where it is
subject to rapid changes in temperature and humidity.
• Ensure that the ClearMark printer is not exposed to direct sunlight,
strong light or excessive heat.
• Avoid locations subject to impact shocks or vibrations. Do not place on
a table joined to other tables to avoid transmission of vibration.
• Do not install the device in dust-filled surroundings.
• When installing, ensure that the ClearMark printer is sufficiently
ventilated on all sides.
• Install the ClearMark Printer near a socket outlet, ensuring that the
plug can be easily removed at all times.
Dimensions of the printer system (including the out-put rail):
• L x W x H, approx. 50 x 19.7 x 11.8 in. (1270 x 500 x 300 mm)
• Weight: Approx. 65 lb. (30 kg)
IMPORTANT A LAN cable and extra ink cartridges are not shipped with printer
IMPORTANT Observe recommended minimum clearance requirements and install
printer on a freely accessible, sturdy, level surface.