Rockwell Automation 1492-PRINT110_PRINT220 ClearMark Printer User Manual - Manual (Page 9)

Rockwell Automation Publication 1492-UM08A-EN-P - June 2010 v
Preface
• Do not open the device when it is printing!
Unplug the ClearMark printer and contact a qualified service engineer if any of
the following occurs:
• The power cord or plug are worn or damaged.
• Fluid has penetrated into the ClearMark printer.
• The ClearMark printer enclosure is damaged.
• The ClearMark printer does not operate normally or the standard of
performance varies noticeably.
Precautionary Measures Observe the following when using the ClearMark printer, handling ink
cartridges, or choosing a location to install the ClearMark printer:
Working with the ClearMark printer
• Check the wipe and scratch resistance of the ink at regular intervals.
• After printing, allow the marker card to cool for a few seconds, then
remove your printouts from the output rail of the ClearMark printer.
• Before transporting the ClearMark printer, ensure that it is switched off,
and that the ink cartridges are installed correctly.
ATTENTION: Only connect the printer to a properly grounded
and correctly-fused outlet. Do not use an outlet already being
used by devices that are turned on and off at regular intervals,
such as photocopiers or fans. Do not connect the ClearMark
printer to either a switched or a timer-controlled outlet.
ATTENTION: Do not use the computer system near possible
electromagnetic disturbance fields such as loudspeakers or base
transceiver stations for mobile telephones.
ATTENTION: Never use damaged or worn power cables. Do not
exceed the nominal ampere rating on extension cords or outlets.
ATTENTION: Do not move the print head by hand, as this could
damage the ClearMark printer. Do not carry out repairs to the
device.
ATTENTION: Always use the main power switch on the
operating panel to turn the ClearMark printer on and off.