Rockwell Automation 1492-PRINT110_PRINT220 ClearMark Printer User Manual - Manual (Page 59)

Rockwell Automation Publication 1492-UM008A-EN-P - June 2010 6-3
First Time Use Chapter 6
Stacking heights
Do not stack the marker cards above the height of the loader paper stop.
Figure 6.
3 - Stacking heights in the loader
After the first marker card has been inserted into the printer, it is printed and fed
out to the ClearMark printer output rail. The next marker card is then separated
out so that it can be fed in and printed.
Heating Settings With some marker cards it may be necessary to adjust the heating settings in order
to optimize the printing quality. Take the necessary settings from the table if
required. These settings are also provided via a message box in the ClearTools
software.
ATTENTION: Do not exceed the maximum permitted stacking
height when filling the loader.
ATTENTION: You can insert complete or half marker cards. Do
not mix complete or half marker cards.
ATTENTION: Under certain circumstances, the card separation
process may malfunction when the maximum amount of marker
cards is inserted. Remove a few of the marker cards from the
loader to rectify this problem.
IMPORTANT If there are no marker cards loaded in the card feeder the "loader" button
on the display will be flashing. Load a marker card and then press the
"loader" button.