Rockwell Automation 1492-PRINT110_PRINT220 ClearMark Printer User Manual - Manual (Page 66)

7-6 Rockwell Automation Publication 1492-UM008A-EN-P - June 2010
Chapter 7 Maintenance
3. Remove ink cartridge.
4. Install new ink cartridge.
5. Check the alignment and the assembly of the ink cartridge carrier. Then
carefully place it into the printer using the following guidelines. Pay special
attention to whether you are installing black or colored inks.
6. Press on the middle of the ink-cartridge carrier and push in until it snaps
into place.
7. Repeat this step for all ink-cartridge carriers.
8. Close the ink-cartridge cover.
Replacing the Ink Collector
Unit
Replace the ink collector unit if the following message is issued in the display:
1. Turn OFF the printer.
2. Remove the new ink collector unit from the packaging. Use the included
gloves.
3. Remove the full ink collector unit from the printer.
IMPORTANT Run through the installation procedure as detailed in the instructions
before turning on the printer!
ATTENTION: If the ink comes into contact with your eyes wash out
immediately with water. If the ink comes into contact with your skin
wash the affected area thoroughly with soap and water. If you
swallow ink rinse your mouth and drink plenty of water.
R e p l a c e I n k
C o l l e c t o r U n i t