Safety precautions – Rockwell Automation 1492-PRINT110_PRINT220 ClearMark Printer User Manual User Manual
Page 8
iv
Rockwell Automation Publication 1492-UM08A-EN-P - June 2010
Preface
Figure
P.2 - Warning Label on Device
Safety Precautions
Read the following instructions carefully before starting up the ClearMark
printer. Observe the warnings and notices on the ClearMark printer at all times.
• The printer weighs approx. 65 lb. (30 kg). Therefore, always use two
people when moving. To lift the printer, use the recessed grips at the front
and rear of the device.
• Do not block or cover openings in the housing of the ClearMark printer.
• Do not insert any unsuitable objects into these openings.
• Do not spill any fluids onto the ClearMark printer.
• The supply voltage must correspond to the system voltage given on the
ClearMark printer serial label located adjacent to the power cord
connections.
ATTENTION: Do not disassemble the printer!
Do not open the printer housing!
This exposes you to a risk of injury!
There are no serviceable parts inside the printer.
You will forfeit all rights under the warranty if you open the
cover!