Rockwell Automation 1734-485ASC POINT I/O ASCII User Manual - Manual (Page 12)

Publication 1734-UM009B-EN-P - July 2003
1-2 Installing the ASCII Module
1. Position the mounting base/wiring base assembly vertically
above the installed units (adapter, power supply or existing
module).
2. Slide the mounting base down allowing the interlocking side
pieces to engage the adjacent module or adapter.
3. Press firmly to seat the mounting base on the DIN rail. The
mounting base will snap into place.
4. To remove the mounting base from the DIN rail, remove any
installed module (and any module immediately to the right), and
use a small bladed screwdriver to rotate the DIN rail locking
screw to a vertical position. This releases the locking
mechanism. Then lift straight up to remove the mounting base.
5. Repeat this procedure for the next mounting base assembly.
TX
RX
Module Status
Network Status
1734
232ASC
NO DE :
Mounting Base
Mechanical Keying
(orange)
Module Wiring Diagram
Module Locking Mechanism
Insertable I/O Module
RTB Removing Handle
Removable Terminal Block (RTB)
DIN Rail Locking Screw
(orange)
Slide-in Writable Label
Interlocking Side Pieces