Rockwell Automation 1734-485ASC POINT I/O ASCII User Manual - Manual (Page 33)

Publication 1734-UM009B-EN-P - July 2003
Configuring Your ASCII Module 2-7
Refer to the screens below for an explanation of its features.
The module’s name appears
here.
Type a description here.
The module’s address appears
here. You can change the node
address if necessary.
This screen also shows the
module’s device identity.
These fields are read-only.
At any point, you can click here to finish
changing configuration parameters.
IMPORTANT: If configuration changes are
made in offline mode , they do not take
effect until the system goes online.
Click on the Device parameters tab
to get to the screen for setting the
parameters.
This screen appears after clicking on
the Device parameters tab. If you
want the existing parameters
uploaded from the module, select
Upload. The following screen will
then show the existing parameters
set on the module.
Use this pulldown menu to
edit or view the parameters.
Available choices are:
PointBus
Configuration
When you have finished configuring your
parameters, download to your module by clicking on
the Download to Device button. You can download
each change as you make it using “Single,” or
download all your changes using “All.”