Rockwell Automation 1734-ACNR POINT I/O ControlNet Adapter User Manual User Manual
Point i/o controlnet adapter
Advertising
Table of contents
Document Outline
- Important User Information
- Summary of Changes
- Table of Contents
- Preface
- Who Should Use This Manual
- Purpose of the Manual
- Common Techniques Used in This Manual
- Terminology
- About the Module
- Chapter Objectives
- Hardware Components
- Install Your Adapter
- Chapter Objectives
- Determine Power Requirements
- Set the Node Address
- Install the Adapter
- Wire the Adapter
- Connect Programming Terminals to the Network via the NAP
- Install the I/O Modules
- Replace an Adapter
- Plan to Use Your Adapter
- Chapter Objectives
- Overview of Adapter Operation
- Connection Limit Exceeded Error
- Understand ControlNet I/O
- Before You Begin
- Configure the Adapter
- Chapter Objectives
- Add Modules to the I/O Configuration
- Add Analog, Digital, Other, or Specialty Modules
- Download the Program to the Controller
- Configure the 1734-ACNR Adapter
- Schedule I/O Module Connections
- Access Module Data via the 1734-ACNR Adapter
- Change Configuration Data
- Recover from an Overloaded 1734-ACNR Adapter
- Diagnostics
- Use the Indicators to Troubleshoot
- 1734-POINT I/O Module/RSLogix5000 Controller Tag Reference
- 1734 POINT I/O Catalog Numbers
- Valid Number Ranges for RSLogix5000 Data Types
- Discrete 2 POINT Input
- Discrete 4 POINT Input
- Discrete 2 POINT Output - Without Diagnostic Status
- Discrete 2 POINT Output - With Over Load and Open Load Diagnostic Status
- Discrete 2 POINT Output - With Over Load Diagnostic Status
- Discrete 4 POINT Output - With Over Load and Open Load Diagnostic Status
- Discrete 4 POINT Output - With Over Load Diagnostic Status
- Analog 2 Channel Input
- Analog 2 Channel Output
- Specialty I/O
- Index