Wire the adapter – Rockwell Automation 1734-ACNR POINT I/O ControlNet Adapter User Manual User Manual
Page 15
Publication 1734-UM008B-EN-P - August 2005
Install Your Adapter 2-3
Wire the Adapter
ATTENTION
Do not discard the end cap. Use this end cap
to cover the exposed interconnections on the
last mounting base on the DIN rail. Failure to
do so could result in equipment damage or
injury from electric shock.
ATTENTION
If you connect or disconnect the
communications cable with power applied to
this module or any device on the network, an
electrical arc can occur. This could cause an
explosion in hazardous location installations.
ATTENTION
If you connect or disconnect wiring while the
field-side power is on, an electrical arc can
occur. This could cause an explosion in
hazardous location installations. Be sure that
power is removed or the area is
nonhazardous before proceeding.