AJA KUMO CP - Manual (Page 17)

KUMO v3.1 www.aja.com 17
compatible with the KUMO temporary IP address. Once connected, the KUMO device’s
network settings can be reconfigured to work with your facility network. The KUMO
default static IP address is temporary and is intended only to allow an initial connection.
NOTE: All KUMO routers and control panels have the same temporary default IP address, so more
than one device set to this default cannot reside on the same network simultaneously. Work
with only one device at a time.
NOTE: The default static address is temporary and will be disabled the next time KUMO restarts. Any
changes in the Network configuration will be saved upon restart.
To set KUMO to its default static IP address:
1. Power up KUMO device and wait for it to boot normally.
2. Reset the KUMO device:
• For a KUMO router, insert a straightened paper clip or similar device into the reset
slot on the rear—hold for six seconds and then allow KUMO to restart. When the
KUMO router default IP is set, the Identify LED will blink.
• For a KUMO CP, press and hold the two SHIFT buttons on the panel for 5 seconds.
When the KUMO CP default IP is set, the Source and Destination buttons will flash
alternately.
Figure 10. KUMO Reset Slot Location
IMPORTANT: Be sure to record your computer’s existing TCP-IP settings before the next step so that
you can return the computer to normal operation after this procedure.
3. Configure your computer to 192.168.101.X. Do not use .1 at the end of the address to
avoid duplicate IP addresses.
NOTE: Specific network reconfiguration procedures for Mac and PC are presented later in this
chapter.
4. Start a web browser and enter 192.168.101.1 as the web address. This is the KUMO
temporary static IP address.
5. Once you’ve connected using the static IP, you can then enter a desired network
configuration using the KUMO device's Network tab.
Table 2. KUMO Device Temporary Static IP Address Values
Device IP address Subnet Mask
KUMO Router and KUMO CP 192.168.101.1 255.255.255.0