ClearCube R-Series Data Center Products - Manual (Page 102)

78 • Hardware Upgrade and Replacement Procedures R-Series Data Center Products User’s Guide
Other components such as the processor or motherboard are not intended for field
replacement. Removal voids your warranty. Contact ClearCube Technical Support for
assistance.
A complete PC blade is easily upgraded by lowering the chassis front bezel, slowly
pulling out the old PC blade, and then replacing with a new PC blade.
Hard Disk Drive (HDD) CRU
*
FRU &
CRU
CRU
See “Replacing and Upgrading Hard
Disks” on page 84
HDD Cable CRU
*
FRU &
CRU
CRU
See “Replacing and Upgrading Hard
Disks” on page 84
Front LCD Panel CRU CRU CRU
See “Replacing a Front LCD Panel” on
page 97.
Chassis Interposer Card CRU CRU CRU
See “Replacing Blade Interposer Cards”
on page 102.
CPU Fan FRU CRU CRU See “Replacing CPU Fans” on page 89.
CMOS Battery CRU CRU CRU
See “Replacing the CMOS Memory
Battery” on page 100.
CPU FRU FRU FRU
Return blade to ClearCube to replace
CPUs.
CPU Heat Sink FRU FRU FRU
Return blade to ClearCube to replace
CPU heat sinks.
Voltage Regulator Module
(VRM) Not
Applicable
FRU
Not
Applicable
Return blade to ClearCube to replace
VRMs.
*
Customers can replace existing R3040S HDDs, but must return R3040S blades to ClearCube to add
additional HDDs. See “R3040S Hard Disks” on page 84 for more information.
Some surfaces on the blade may be hot, especially when the blade
has been powered on. Remove and handle the blade with care.
Table 11: Blade Components and CRU/FRU Designation
Blade Component R1350 R3040S R3080D Instructions