ClearCube R-Series Data Center Products - Manual (Page 110)

86 • Hardware Upgrade and Replacement Procedures R-Series Data Center Products User’s Guide
2. Position the blade so the hard disk tray is facing up (the hard disk tray is located
on the left side of the blade if you are looking at the front of the blade).
3. Use a a Phillips screw driver to remove the four screws (M3 x 5, flat head screw,
part number G7110009) from the hard disk tray, located on the top of the blade.
4. Use the finger holes in the center of the tray to carefully raise tray. Do not pull the
tray straight up; rotate the tray on the its long edge as shown in the following figure.
Figure 46 Remove the Hard Disk Tray by Rotating on the Long Edge Closest to Bottom of Blade
5. Remove SATA data cables and power cables from the hard disks.
6. Remove the four screws (M3 x 5, flat head screw, part number G7110009)
securing each hard disk to the tray. Ensure that you save these screws to use when
replacing each hard disk.
NOTE:
Before disconnecting any SATA cables, note their position so
you can easily reconnect each cable to the correct hard disk.
Figure 45 on page 85 shows hard disk cables and header
numbering.
Bottom of Blade Remove Hard Disk Tray by
Rotating on the Long Edge
Closest to the Bottom of the Blade