ClearCube R-Series Data Center Products - Manual (Page 123)

R-Series Data Center Products User’s Guide Hardware Upgrade and Replacement Procedures • 99
shown below. It might help to push up on the lower tab from the outside of the
blade.
c. When the panel is clear of the USB connector, pull the panel out of the blade.
5. Remove the LCD by grasping the end of the cable and by grasping the base of the
LCD panel. Pull apart to separate.
6. Connect the LCD cable and the replacement front LCD panel.
7. Insert the replacement LCD in the blade (it can be helpful to rotate the LCD panel
before inserting it in the blade). Insert the tab into the slot and push down to fully
seat the panel. Ensure that the bump on the bottom of the LCD panel rests in the
hole in the center of the supporting surface.
Ensure That Plastic Tab Is
Clear of Blade Frame
Hole
Bump