ClearCube R-Series Data Center Products - Manual (Page 13)

R-Series Data Center Products User’s Guide Introduction • xiii
Safety Guidelines
Before undertaking any troubleshooting or maintenance procedure, read carefully all
WARNING and CAUTION notices. This equipment contains voltage hazardous to
human life and is capable of inflicting personal injury.
• Installations – ClearCube equipment is required to be installed in accordance
with the local electrical codes and may be subject to inspection by the authority
having jurisdiction.
• Chassis Grounding – ClearCube’s chassis and Fiber Transceiver have been
designed with a three-conductor IEC 60320 appliance inlet that – with the proper
power cord – connects the building’s external protective earthing conductor to all
accessible metal parts of the enclosure. To minimize shock hazard, make sure
your electrical power outlet has an appropriate earth safety ground that is
connected each time you power on the equipment.
Swedish safety regulations require the following statement:
—Apparaten skall anslutas till jordat uttag när den anslutas till ett nätuerk.—
Finnish safety regulations require the following statement:
— Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan.—
• Power Cord Selection – ClearCube or ClearCube’s Distributors provides power
cords that are specifically designed for use with that particular piece of equipment
and are approved for use by the local authority having jurisdiction in the country
where the equipment is put into service. Please refer to the installation sections of
this manual for specific power cord requirements. For replacement of power
cords, refer to Appendix C – Technical Support.
• Power Adapters – ClearCube or ClearCube’s Distributors provides power
adapters that are specifically designed for use with that particular piece of
equipment and are approved for use by the local authority having jurisdiction in
the country where the equipment is put into service. Please refer to the installation
sections of this manual for specific power cord requirements. For replacement of
power cords, refer to Appendix C – Technical Support.
• IT Power Systems – ClearCube equipment has been evaluated and found to be
compatible with IT power distribution systems with a phase-to-phase voltage not
to exceed 240 V.
WARNING: A Warning notice in this manual indicates that catastrophic
equipment damage, or serious injury including death may result if
proper procedures are not followed.