Metrohm 881 Compact IC pro – Cation - Manual (Page 20)

3.3 Installation diagram
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭
881 Compact IC pro – Cation
￭ Connect the separation column (see Chapter 3.17, page 44)
– Fasten the inlet of the separation column either to the end
of the column inlet capillary (3-2) or to the guard column (if
used) (see leaflet to the separation column).
– Fasten the detector inlet capillary (3-3) using a PEEK pres-
sure screw (6.2744.070) to the output of the separation
column.
￭ Hang separation column with chip in the column holder of the
instrument.
8 Conditioning the instrument
See Chapter 4.2, Page 48.
The instrument is now ready for measuring samples.
3.3 Installation diagram
The following installation diagram shows the schematics of the front of
the instrument after installation is complete. Many capillaries are already
installed at the time the instrument is delivered; these capillaries are not
numbered in the diagram. Numbered capillaries must be connected at the
time of installation.