Metrohm 881 Compact IC pro – Cation - Manual (Page 35)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
881 Compact IC pro – Cation
￭￭￭￭￭￭￭￭ 27
Connecting the eluent degasser
5
6
1
2
3
4
Figure 13 Eluent degasser
1 Eluent degasser input 2 Eluent degasser output
3 Tubing flare
With tubing nipple. 4 Clamping screw
5 Eluent aspiration tubing (6.1834.080)
For aspirating the eluent. The clamping
screw (13-
4 ) is firmly mounted.
6 Connection tubing (6.1834.090)
Connection from the eluent degasser to the
high pressure pump (see Chapter 3.10, page
28). The clamping screw (13-
4 ) is firmly
mounted.
1
Caution
The clamping screws (13-4) must be tightened carefully. Use the
wrench (6.2621.050) to do this.
￭ Insert the eluent aspiration tubing (13-5) into the eluent degasser
input (13-1).
￭ Carefully tighten the clamping screw (13-4).
2 ￭ Insert connection capillary (13-6) (the end with the longer clamp-
ing screw (13-4)) into the eluent degasser output (13-2).
￭ Carefully tighten the clamping screw (13-4).
￭ Connect the other end of the connection capillary (13-6) (with
the shorter clamping screw ) to the high pressure pump (14-9)
(see "Connecting inlet to the high pressure pump", page 29).