Metrohm 858 Professional Sample Processor - Manual (Page 25)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
858 Professional Sample Processor ￭￭￭￭￭￭￭￭ 17
If the Swing Head is not connected, connect it as follows:
1 Plug in the cable
Guide the Swing Head connection cable through the guide chain of
the tower (see Chapter 3.7, page 23) and plug the Mini DIN plug
into the 'Swing Head' socket.
3.3 Connecting the mains cable
Warning
This instrument may only be used with the mains voltage specified (see
rear of the instrument).
Protect the connection sockets against moisture.
P: 115W U: 100 - 240 V f: 50 - 60 Hz
Nr
.
Figure 11 Connecting the mains cable
3.4 Mounting the retaining plate
When removing samples from sealed vessels with the needle, the
6.2064.000 retaining plate is used for stripping vials while the lift is mov-
ing upward.