Sindoh M611 - Manual (Page 217)

5-
17
5
Maintenance and Troubleshoot
5. Understanding of MFP Messages
The LCD of the control panel is designed to display the current status and problems. This section describes
messages and how to respond them.
Messages Meanings Actions
Invalid Cartridge No or unsupported cartridge Reinstall the cartridge. If this message ap-
pears again, replace the cartridge..
Cover Open The front cover is open. Close the cover.
Cancel Job? This message appears when press-
ing 【 】 or cancel the job in job Man-
ager window while copying, scanning
or faxing.
Factory Defaults
Restoring
Factory defaults are being restored.
(Toner Low) The toner is low Shake the catridge to use the remaining
toner. Replace the cartridge
Reference
- If you don’t replace the cartridge, qual-
ity problems can occur. Also, the ma-
chine will stop after printing a few more
sheets.
Replace Toner
Cartridge
The toner cartridge reaches its life
and should be replaced.
Replace the cartridge with a new one.
Tray Empty(T1) No paper on Tray 1 Load paper on Tray 1.
Tray Empty(T2) No paper on Tray 2. Load paper on Tray 2.
Tray Empty(T3) No paper on Tray 3 Load paper on Tray 3.
Tray
Empty(MPT)
No paper on Multi-purpose Tray Load paper on MPT.
Paper Jam
[Tray]
Paper is not fed from tray(Tray1-3 or
MPT)
Make sure the paper is well loaded on the
tray
Paper Jam
inside(4)
Paper is jammed in MFP Open the front cover, pull out the cartridge
and remove the paper stuck in the paper
path
Paper Jam
inside(5) Paper is stuck in MFP Open the front cover, pull out the cartridge
and remove the paper stuck in the paper
path